Installing the system board shroud – Dell PowerEdge R415 User Manual
Page 110
Advertising
110
Installing System Components
Figure 3-16. Removing and Installing the System Board Shroud
Installing the System Board Shroud
1 Open the system. See "Opening the System" on page 82.
2 Align the shroud using center of the numbered fan bays as a guide and
locate the tab projection on the left side of the fan module numbered 3.
3 Push the system board shroud down until all edges are seated in the slots,
securing the shroud to the system board.
4 Route the cables appropriately through the cable holders on the system
board shroud.
5 Close the system. See "Closing the System" on page 83.
1
system board shroud
2
shroud tab (2)
1
2
R415HOM.book Page 110 Friday, September 24, 2010 9:37 AM
Advertising