Dell PowerEdge R415 - Manual (Page 125)

Installing System Components 125
5 Press the ejectors on the memory module socket down and out, as shown
in Figure 3-22, to allow the memory module to be inserted into the socket.
6 Handle each memory module only on either card edge, making sure not to
touch the middle of the memory module.
Figure 3-22. Installing and Removing a Memory Module
7 Align the memory module's edge connector with the alignment key of the
memory module socket, and insert the memory module in the socket.
NOTE: The memory module socket has an alignment key that allows you to
install the memory module in the socket in only one way.
8 Press down on the memory module with your thumbs to lock the memory
module into the socket.
When the memory module is properly seated in the socket, the ejectors on
the memory module socket align with the ejectors on the other sockets
that have memory modules installed.
9 Repeat step 5 through step 8 of this procedure to install the remaining
memory modules. See Table 3-3 and Table 3-4.
1 memory module 2 memory module socket ejector (2)
3 alignment key
2
1
3
R415HOM.book Page 125 Friday, September 24, 2010 9:37 AM