Dell PowerEdge R415 - Manual (Page 45)

About Your System 45
Keyboard data
line failure.
Keyboard stuck
key failure. Keyboard cable connector is
improperly connected or the
keyboard is defective.
Reseat the keyboard cable. If
the problem persists, see
"Troubleshooting a USB
Device" on page 150.
Keyboard fuse has
failed. Overcurrent detected at the
keyboard connector.
See "Getting Help" on
page 181.
Local keyboard
may not work
because all user
accessible USB
ports are
disabled. If
operating
locally, power
cycle the system
and enter system
setup program to
change settings. The USB ports are disabled
in the system BIOS.
Power down and restart the
system using the power
button, and then enter the
System Setup program to
enable the USB port(s). See
"Entering the System Setup
Program" on page 58.
Manufacturing
mode detected. System is in manufacturing
mode.
Reboot to take the system
out of manufacturing mode.
Memory tests
terminated by
keystroke. POST memory test was
terminated by pressing the
spacebar.
Information only.
Table 1-3. System Messages (continued)
Message Causes Corrective Actions
R415HOM.book Page 45 Friday, September 24, 2010 9:37 AM