Dell PowerEdge R415 User Manual
Page 50
50
About Your System
Unable to launch
System Services
image. System
halted!
System halted after <F10>
keystroke because System
Services image is either
corrupted in the system
firmware or has been lost due
to system board replacement.
Restart the system and
update Lifecycle Controller
by running the Lifecycle
Controller Dell Update
Package (DUP). For more
information, see the Dell
Update Packages User's
Guide at
support.dell.com/manuals.
If the system still reports the
same error, run the Lifecycle
Controller Repair Package.
Follow the instructions
provided with the package to
complete the installation.
The iDRAC6 Enterprise card
flash memory may be
corrupted.
Unexpected
interrupt in
protected mode.
Improperly seated memory
modules or faulty
keyboard/mouse controller
chip.
Reseat the memory modules.
page 157. If the problem
persists, see "Getting Help"
Unsupported CPU
combination.
Unsupported CPU
stepping
detected.
Processor(s) not supported
by the system.
Install a supported processor
or processor combination.
Unsupported DIMM
detected. The
following DIMM
has been
disabled: x
Invalid memory
configuration. The system
will run but with the
specified memory module
disabled.
Ensure that the memory
modules are installed in a
valid configuration. See
Table 1-3. System Messages
(continued)
Message
Causes
Corrective Actions
R415HOM.book Page 50 Friday, September 24, 2010 9:37 AM