Dell PowerEdge R415 - Manual (Page 139)

Installing System Components 139
Installing the Control Panel Assembly
CAUTION: Many repairs may only be done by a certified service technician.
You should only perform troubleshooting and simple repairs as authorized in
your product documentation, or as directed by the online or telephone service
and support team. Damage due to servicing that is not authorized by Dell is
not covered by your warranty. Read and follow the safety instructions that
came with the product.
1 For LED control panel, proceed to step 3. Insert the display module into
the chassis cutout and secure with the two screws.
2 Affix the replacement panel to the front of the display module.
3 Align the slot in the control panel board with the standoff on the system
chassis and secure with the two screws. See Figure 3-29. For LED control
panel, skip step 4.
4 Connect the display module cable to the control panel board.
5 Connect the control panel cable to the control panel board.
6 Close the system. See "Closing the System" on page 83.
7 If applicable, replace the front bezel. See "Installing the Front Bezel" on
page 81.
R415HOM.book Page 139 Friday, September 24, 2010 9:37 AM