System identification indicators, Front-panel indicators and features – Dell PowerVault 775N (Rackmount NAS Appliance) User Manual
Page 15
Blinking Off
Blue blinking
The system is identifying itself (see "
System Identification Indicators
System Identification Indicators
The identification buttons on the front and back panels can be used to identify a particular system within a rack. See
to locate the front-panel system identification button. See
to locate the back-panel system identification
button and indicator.
When either of the identification buttons is pushed, the identification indicator on the back blinks until one of the buttons is
pushed again. If the bezel is installed, the system status indicator will also blink. If an indicator is connected to the back-
panel system status indicator connector, that indicator will also blink.
Systems management software can also be used to cause the status and identification indicators to blink to identify a
particular system. For more information, see the systems management software documentation.
Front-Panel Indicators and Features
Additional indicators are located behind the bezel. The front-panel status LCD provides information using an alphanumeric
character display (see "
"). See
for the front-panel indicators and features.
describes the front-panel features.
Figure 3-2. Front-Panel Features
Table 3-2. Front-Panel Features
Component Description
Power
button
Turns system power off and on.
The button is enabled in the System Setup program. When disabled, the button can only turn system power
on. For more information, see your User's Guide and the operating system's documentation.
Power
indicator
Provides information on power status (see "
CD and
diskette
Indicates read or write access to the respective drive.