Dell PowerVault 775N (Rackmount NAS Appliance) - Manual (Page 23)

microprocessor(s) (see
" Microprocessors ").
E07F4 POST CPU SMI SMI handler failed to initialize;
faulty system board.
Replace the system board (see
" System Board ").
E07FA TEMP CPU n
THERM Specified microprocessor is out of
acceptable temperature range and
is operating at a reduced speed, or
frequency.
Ensure that the system cooling fans
are properly installed. If the problem
persists, replace the faulty fan(s)
(see " System Fans "). If the problem
persists, ensure that the
microprocessor heat sinks are
properly installed. If the problem
persists, replace the faulty
microprocessor (see
" Microprocessors ").
E0876 POWER PS n No power available from the
specified power supply; specified
power supply is improperly
installed or faulty.
Ensure that the power supplies are
properly installed. If the problem
persists, replace the faulty power
supply(ies) (see " Power Supplies ").
E0880 INSUFFICIENT PS Insufficient power is being supplied
to the system; power supplies are
improperly installed, faulty, or
missing.
E0CB2 MEM SPARE BANK Correctable errors threshold was
met in a memory bank: errors
were remapped to the spare bank.
Ensure that the memory modules are
properly installed. If the problem
persists, replace the faulty memory
module(s) (see " Memory Modules ").
E0CF1 MBE DIMM Bank n Memory modules installed in the
specified bank are not the same
type and size; faulty memory
module(s).
Ensure that all banks contain
memory modules of the same type
and size and that they are properly
installed. If the problem persists,
replace the faulty memory module(s)
(see " Memory Modules ").
E0CF1 POST MEM 64K Parity failure in the first 64 KB of
main memory.
Ensure that the memory modules are
properly installed. If the problem
persists, replace the faulty memory
module(s) (see " Memory Modules ").
E0CF1 POST NO MEMORY Main-memory refresh verification
failure.
Ensure that all banks contain
memory modules of the same type
and size and that they are properly
installed. If the problem persists,
replace the faulty memory module(s)
(see " Memory Modules ").
E0CF5 LOG DISABLE SBE Multiple single-bit errors on a
single memory module.
Ensure that the memory modules are
properly installed. If the problem
persists, replace the faulty memory
module(s) (see " Memory Modules ").
E0D76 DRIVE FAIL Faulty or improperly installed hard
drive or RAID controller.
Ensure that the hard drives are
properly installed. If the problem
persists, replace the faulty hard
drive(s) (see " Hard Drives "). If the
problem persists, replace the RAID
controller (see " Integrated RAID
Controller " and " RAID Controller
Card ").
E0F04 POST CMOS CMOS write/read failure; faulty
system board.
Replace the system board (see
" System Board ").
E0F04 POST CPU SPEED Microprocessor speed control
sequence failure.
Ensure that the microprocessors are
properly installed. If the problem
persists, replace the faulty
microprocessor(s) (see