Removing the cd and diskette drives from the tray – Dell PowerVault 775N (Rackmount NAS Appliance) User Manual
Page 54
CAUTION:
See "Protecting Against Electrostatic Discharge" in the safety instructions in your System
Information document.
1. Align the CD/diskette drive tray with the opening in the front panel.
2. Press the CD/diskette drive tray release handle until the tray snaps into place (see
3. Reconnect your system and peripherals to their electrical outlets, and turn on the system.
4. Replace the bezel (see "
").
Removing the CD and Diskette Drives From the Tray
CAUTION:
See "Protecting Against Electrostatic Discharge" in the safety instructions in your System
Information document.
1. Remove the CD/diskette drive tray (see "
Removing the CD/Diskette Drive Tray
2. Disconnect the cable from the CD drive by pulling the cable connector away from the drive connector (see
).
3. Loosen the thumbscrew on the drive tray brace and remove the brace (see
).
4. Lift the CD drive up and to the right, away from the drive tray. (see
NOTE:
If you are only replacing the CD drive, it is not necessary to remove the diskette drive from the drive
tray. Go to the procedure, "
Replacing the CD and Diskette Drives on the Tray
5. Disconnect the cable from the diskette drive (see
):
a. Pull the securing latch on the drive's connector upward to release the cable.
b. Slide the cable out of the drive's connector.
6. Lift the diskette drive up and to the right, away from the drive tray.
Figure 4-16. Removing and Replacing the CD and Diskette Drives