Dell PowerVault 775N (Rackmount NAS Appliance) User Manual
Page 78
CAUTION:
See "Protecting Against Electrostatic Discharge" in the safety instructions in your System
Information document.
1. Replace the system board (see
):
a. Lower the front of the system board into the system board tray, under the tray levers.
b. Lower the system board onto its grounding tabs in the system board tray and slide the system board back until
the board's plunger snaps into place.
2. Replace the system board tray (see "
Replacing the System Board Tray
").
3. Replace the system battery (see "
4. Replace the microprocessors and VRMs (see "
Adding or Replacing a Microprocessor
5. If necessary, replace the memory module, hardware key, and battery for the integrated RAID controller (see "
the Integrated RAID Controller
").
6. Install the memory modules (see "
").
7. Replace the expansion-card cage (see "
Replacing the Expansion-Card Cage
8. Replace the system fan bracket (see "
Replacing the System-Fan Bracket
9. Replace the cooling fans (see "
10. Replace the power supplies (see "
11. Replace the cover (see "
").
12. Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.