Scsi configuration information, Replacing the cd/diskette drive cable – Dell PowerVault 775N (Rackmount NAS Appliance) User Manual
Page 57
Replacing the CD/Diskette Drive Cable
CAUTION:
See "Protecting Against Electrostatic Discharge" in the safety instructions in your System
Information document.
1. Replace the drive cable assembly on the tray bracket (see
):
a. Align the holes in the cable assembly board with the holes in the tray bracket.
b. Replace the two rivet collars in the board.
c. Replace the two rivets that secure the board to the tray bracket.
2. If you removed the CD and diskette drives from the tray, replace the drives on the tray (see "
3. If you did not remove the CD and diskette drives from the tray, connect the cable to the drives (see
):
a. Connect the cable to the diskette drive by raising the securing latch on the drive's connector to the released
position, sliding the cable into the drive's connector, and pressing the cable securing latch into the locked
position.
b. Connect the cable to the CD drive by pressing the cable connector to the drive connector.
4. Replace the CD/diskette drive tray (see "
Replacing the CD/Diskette Drive Tray
SCSI Configuration Information
Although SCSI devices are installed in essentially the same way as other devices, their configuration requirements are
different. To install and configure an external SCSI device, follow the guidelines in the following subsections.