Dell PowerVault 775N (Rackmount NAS Appliance) User Manual
Page 29
persists, replace the faulty
microprocessor(s) (see
"
"). If the problem
persists, replace the system board
(see "
").
Processor in socket 1 not
installed!
No microprocessor installed
in primary microprocessor
socket.
Install a microprocessor in the
primary microprocessor socket. Also,
ensure that a VRM for processor 1 is
installed (see "
Remote access controller
error
Embedded remote access
memory may be temporarily
corrupted.
To clear the embedded remote
access memory, shut down the
system, disconnect the power cords,
wait approximately 30 seconds,
reconnect the power cords, and
restart the system. If the problem
persists, ensure that the expansion-
card riser board is properly installed.
If the problem persists, replace the
expansion-card riser board (see
"
"). If
the problem persists, replace the
system board (see "
Remote access controller is
not present
SCSI cable not present on
connector A or B of the
primary backplane
SCSI cable is loose,
improperly connected, or
faulty.
Ensure that the SCSI cables are
properly installed. If problem
persists, add or replace the cables.
Shutdown failure
Shutdown test failure.
Ensure that the memory modules
are properly installed. If the problem
persists, replace the faulty memory
module(s) (see "
").
System backplane error
Faulty or improperly installed
SCSI backplane board.
Ensure that the SCSI backplane
board is properly installed. If the
problem persists, replace the
backplane board (see "
System halted! Must power
down
Wrong password entered too
many times.
Information only.
Time-of-day clock stopped
Faulty battery.
Ensure that the system battery is
properly installed. If the problem
persists, replace the battery (see
"
Time-of-day not set - please
run SETUP program
Incorrect Time or Date
settings; faulty system
battery.
Check the Time and Date settings
(see "
"). If the problem persists,
replace the system battery (see
"
Timer chip counter 2 failed
Faulty system board.
Replace the system board (see
"
Unsupported CPU combination
Microprocessor(s) is not
supported by the system.
Update the BIOS firmware.
Download the latest firmware from
the Dell | Support website at
support.dell.com. If the problem
persists, install a supported
microprocessor combination (see
"
Unsupported CPU stepping
detected
Unsupported DIMM detected in
the RAID DIMM slot!
RAID memory module is not
supported by the system.
Install a correct version of the RAID
memory module (see "
").
Unsupported RAID key detected!
RAID hardware key is not
supported by the system.
Install the RAID hardware key for
your specific system (see
"
").