Replacing the expansion-card cage – Dell PowerVault 775N (Rackmount NAS Appliance) User Manual
Page 45
3. Disconnect all expansion-card cables.
4. Rotate the expansion-card cage lever up until the cage is released from the chassis (see
).
5. Lift the cage straight up to clear the chassis (see
).
Figure 4-11. Removing and Installing the Expansion-Card Cage
Replacing the Expansion-Card Cage
CAUTION:
Before you perform this procedure, read the safety instructions in your System Information
document.
CAUTION:
See "Protecting Against Electrostatic Discharge" in the safety instructions in your System
Information document.
NOTICE:
To avoid damage to the system, keep the bottom of the expansion-card cage parallel to the system board,
while lowering the cage into the chassis.
1. With the expansion-card cage lever in the upright position, carefully lower the cage into the chassis until it is aligned
with the tabs on the chassis side wall (see
2. Rotate the expansion-card cage lever down until the handle is flush with the top of the cage, and the cage is secured in
the chassis (see
3. Reconnect all expansion-card cables.
4. Replace the cover (see "
").