Integrated raid, Controller, Integrated – Dell PowerVault 775N (Rackmount NAS Appliance) User Manual
Page 61: Raid controller, Integrated raid controller, Activating the integrated raid controller, Installing a hard drive, On a carrier, Installing a hard drive on a carrier
CAUTION:
See "Protecting Against Electrostatic Discharge" in the safety instructions in your System
Information document.
1. Remove the hard drive from the system (see "
2. Remove the four screws that secure the drive to the carrier (see
3. Remove the hard drive from the carrier.
Figure 4-19. Removing a Hard Drive From its Carrier
Installing a Hard Drive on a Carrier
CAUTION:
See "Protecting Against Electrostatic Discharge" in the safety instructions in your System
Information document.
1. Insert the replacement hard drive into the carrier (see
).
2. Install the four screws that secure the drive to the carrier.
3. Install the hard drive in the system (see "
Integrated RAID Controller
The integrated RAID controller in your NAS system is activated when you receive it. The RAID controller memory module,
hardware key, and battery must be present for the integrated RAID controller to operate properly.
To activate the integrated RAID controller, you must install three components, the RAID controller memory module, hardware
key, and battery.
Activating the Integrated RAID Controller
CAUTION:
Before you perform this procedure, read the safety instructions in your System Information
document.