Dell PowerVault 775N (Rackmount NAS Appliance) - Manual (Page 56)

a. Lower the left side of the drive to the tray with the tray's pins aligned with the drive's holes.
b. Lower the right side of the drive onto the tray.
4. Replace the drive tray brace by aligning the end of the brace with the notch on the tray, and then tighten the brace's
thumbscrew (see Figure 4-16 ).
5. Connect the cable to the CD drive by pressing the cable connector to the drive connector.
6. Replace the CD/diskette drive tray (see " Replacing the CD/Diskette Drive Tray ").
Removing the CD/Diskette Drive Cable
CAUTION: See "Protecting Against Electrostatic Discharge" in the safety instructions in your System
Information document.
1. Remove the CD/diskette drive tray (see " Removing the CD/Diskette Drive Tray ").
NOTE: You do not have to remove the CD and diskette drives from the tray to remove the drive cable (see
" Removing the CD and Diskette Drives From the Tray "). However, you must disconnect the cable from the drives
to replace the cable.
2. If you did not remove the CD and diskette drives from the tray, disconnect the cable from the drives (see Figure 4-16 ):
a. Disconnect the cable from the CD drive by pulling the cable connector away from the drive.
b. Disconnect the cable from the diskette drive by pulling the securing latch on the drive's connector upward to
release the cable, and then sliding the cable out of the drive's connector.
3. Remove the drive cable assembly from the tray bracket (see Figure 4-17 ):
a. Remove the two rivets that secure the cable assembly board to the tray bracket.
b. Remove the two rivet collars from the board.
c. Lift the board away from the tray bracket.
Figure 4-17. Removing the CD/Diskette Drive Cable