Dell PowerVault 775N (Rackmount NAS Appliance) - Manual (Page 44)

1. Squeeze the latch at the bottom of the power-supply handle.
2. Rotate the power-supply handle up until the power supply is released from the chassis (see Figure 4-10 ).
3. Pull the power supply straight out to clear the chassis (see Figure 4-10 ).
Figure 4-10. Removing and Installing a Power Supply
Replacing a Power Supply
1. With the power-supply handle in the extended position, slide the new power supply into the chassis (see Figure 4-10 ).
2. Rotate the handle down until it snaps into place (see Figure 4-10 ).
NOTE: After installing a new power supply, allow several seconds for the system to recognize the power supply and
determine whether it is working properly. The power- on indicator will turn green to signify that the power supply is
functioning properly (see " Power Indicator Codes ").
Expansion-Card Cage
The removable expansion-card cage simplifies many installation procedures by allowing you to remove the riser board and all
installed expansion cards in a single step.
Removing the Expansion-Card Cage
CAUTION: Before you perform this procedure, read the safety instructions in your System Information
document.
CAUTION: See "Protecting Against Electrostatic Discharge" in the safety instructions in your System
Information document.
1. Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet.
2. Remove the cover (see " Removing the Cover ").