Dell PowerVault 775N (Rackmount NAS Appliance) - Manual (Page 22)

E0212 VOLT BP 12 Backplane board is out of
acceptable voltage range.
Ensure that the power cables are
securely connected to the backplane
board (see " SCSI Backplane Board ").
Ensure that the power supplies are
properly installed. If the problem
persists, replace the faulty power
supply(ies) (see " Power Supplies ").
E0212 VOLT BP 3.3
E0212 VOLT BP 5
E0212 VOLT CPU VRM Microprocessor VRM voltage is out
of acceptable range; faulty or
improperly installed microprocessor
VRM; faulty system board.
Ensure that supported VRMs of the
same type are properly installed. If
the problem persists, replace the
VRMs (see Figure 4-30 ). If the
problem persists, replace the system
board (see " System Board ").
E0212 VOLT NIC 1.8V Integrated NIC voltage is out of
acceptable range; faulty or
improperly installed power supply;
faulty system board.
Ensure that the power supplies are
properly installed. If the problem
persists, replace the faulty power
supply(ies) (see " Power Supplies ").
If the problem persists, replace the
system board (see " System Board ").
E0212 VOLT NIC 2.5V
E0212 VOLT PLANAR REG System board is out of acceptable
voltage range; faulty or improperly
installed system board.
E0276 CPU VRM n Specified microprocessor VRM is
faulty, unsupported, improperly
installed, or missing.
Ensure that supported VRMs of the
same type are properly installed. If
the problem persists, replace the
VRM (see Figure 4-30 ).
E0276 MISMATCH VRM n
E0280 MISSING VRM n
E0319 PCI OVER
CURRENT Faulty or improperly installed
expansion card.
Ensure that the expansion cards are
properly installed. If the problem
persists, replace the faulty expansion
card(s) (see " Expansion Cards ").
E0412 RPM FAN n Specified cooling fan is faulty,
improperly installed, or missing.
Ensure that the system cooling fans
are properly installed. If the problem
persists, replace the faulty fan(s)
(see " System Fans ").
E0780 MISSING CPU 1 Microprocessor is not installed in
socket 1.
A microprocessor must be installed
in socket 1, and a VRM must be
installed for each installed
microprocessor. Install a
microprocessor in the specified
socket or remove the VRM for the
specified microprocessor if that
microprocessor is not installed (see
" Microprocessors "). To identify the
microprocessors and VRMs, see
Figure 5-3 .
E07F0 CPU IERR Faulty or improperly installed
microprocessor.
Ensure that the microprocessors are
properly installed. If the problem
persists, replace the faulty
microprocessor(s) (see
" Microprocessors ").
E07F1 TEMP CPU n HOT Specified microprocessor is out of
acceptable temperature range and
has halted operation.
Ensure that the system cooling fans
are properly installed. If the problem
persists, replace the faulty fan(s)
(see " System Fans "). If the problem
persists, ensure that the
microprocessor heat sinks are
properly installed. If the problem
persists, replace the faulty
microprocessor (see
" Microprocessors ").
E07F4 POST CACHE Faulty or improperly installed
microprocessor.
Ensure that the microprocessors are
properly installed. If the problem
persists, replace the faulty
E07F4 POST CPU REG