Replacing the control panel – Dell PowerVault 775N (Rackmount NAS Appliance) User Manual
Page 40
1. Remove the control-panel cable cover (see "
Removing the Control-Panel Cable Cover
2. Remove the front-panel I/O board (see "
Removing the Front-Panel I/O Board
").
3. Remove the screws that secure the control-panel assembly in the system (see
Two screws at the top of the control-panel assembly that secure the assembly to the front panel.
One screw at the bottom of the control-panel that secures the assembly to the bottom of the chassis.
4. Slide the control-panel assembly away from the front panel.
5. Lift the assembly and disconnect the cable from the control panel board (see
).
6. Lift the assembly out of the system (see
Figure 4-7. Removing and Replacing the Control-Panel Assembly
Replacing the Control Panel
CAUTION:
Before you perform this procedure, read the safety instructions in your System Information
document.
CAUTION:
See "Protecting Against Electrostatic Discharge" in the safety instructions in your System
Information document.
1. Lower the control-panel assembly into the system.
2. Connect the control-panel cable to the control panel board (see
).
3. Align the assembly with the posts on the front panel (see
).
4. Replace the screws that secure the control-panel assembly in the system (see
Two screws at the top of the control-panel assembly that secure the assembly to the front panel.
One screw at the bottom of the control-panel that secures the assembly to the bottom of the chassis.