Dell PowerVault 775N (Rackmount NAS Appliance) - Manual (Page 60)

5. Replace the bezel (see " Replacing the Bezel ").
6. If your replacement hard drive does not have a carrier, remove the faulty drive from its carrier (see " Removing a Hard
Drive From Its Carrier ").
Installing a Hard Drive
NOTICE: When installing a hard drive, ensure that the adjacent drives are fully installed. Inserting a hard-drive carrier
and attempting to lock its handle next to a partially installed carrier can damage the partially installed carrier's shield
spring and make it unusable.
1. Remove the bezel (see " Removing the Bezel ").
2. If your replacement hard drive does not have a carrier, install the new drive on a carrier (see " Installing a Hard Drive
on a Carrier ").
3. Open the hard-drive carrier handle (see Figure 4-18 ).
NOTICE: Do not insert a hard-drive carrier and attempt to lock its handle next to a partially installed carrier. Doing so
can damage the partially installed carrier's shield spring and make it unusable. Ensure that the adjacent drive carrier is
fully installed.
4. Insert the hard-drive carrier into the drive bay (see Figure 4-18 ).
5. Close the hard-drive carrier handle to lock it in place.
6. Replace the bezel (see " Replacing the Bezel ").
7. Install any required SCSI device drivers (see "Installing and Configuring SCSI Drivers" in the User's Guide for
information).
8. If the hard drive is new, run the SCSI controllers test in system diagnostics.
Removing a Hard Drive From Its Carrier