Dell PowerVault 775N (Rackmount NAS Appliance) - Manual (Page 28)

Memory high data line failure
at start address to end
address
Memory odd/even logic failure
at start address to end
address
Memory parity failure at
start address to end address
Memory parity error at
address
Memory write/read failure at
address, read value expecting
value
No boot device available Faulty or missing CD/diskette
drive subsystem, hard drive,
or hard-drive subsystem.
Check the configuration settings in
the System Setup program for
Integrated Devices (see " Using
the System Setup Program "). If
booting from a SCSI controller,
ensure that the controller is properly
connected. If the problem persists,
replace the faulty drive(s) (see " CD
and Diskette Drives " and " Hard
Drives "). If the problem still
persists, replace the system board
(see " System Board ").
No boot sector on hard- disk No operating system on hard
drive.
Check the hard-drive configuration
settings in the System Setup
program (see " Using the System
Setup Program ").
No PXE-capable device
available <F12> pressed during POST
and no PXE devices are
detected.
Check the configuration settings in
the System Setup program for the
NICs (see " Using the System Setup
Program ").
No timer tick interrupt Faulty system board. Replace the system board (see
" System Board ").
Not a boot diskette No operating system on
diskette.
Use a bootable diskette.
PCI BIOS failed to install Loose cables to expansion
card(s); faulty or improperly
installed expansion card.
Ensure that cables to expansion
cards are properly connected.
Ensure that the expansion cards are
properly installed. If the problem
persists, replace the faulty
expansion card(s) (see " Expansion
Cards ").
Plug & Play Configuration
Error Embedded xxx Error encountered in
initializing PCI device; faulty
system board.
Install the NVRAM_CLR jumper and
reboot the system (see Figure 5-2
for jumper location). If the problem
persists, ensure that the expansion
cards are properly installed. If the
problem persists, replace the faulty
expansion card(s) (see " Expansion
Cards "). If the problem persists,
update the BIOS firmware.
Download the latest firmware from
the Dell | Support website at
support.dell.com.
Plug & Play Configuration
Error PCI_n Error encountered in
initializing PCI adapter.
Primary backplane is not
present Faulty or improperly installed
SCSI backplane board.
Ensure that the SCSI backplane
board is properly installed. If the
problem persists, replace the
backplane board (see " SCSI
Backplane Board ").
Processor n internal error Faulty microprocessor; faulty
system board.
Ensure that the microprocessors are
properly installed. If the problem
Processor bus parity error