Rear panel, Rear panel components, Rear panel component descriptions – Dell PowerVault TL1000 User Manual
Page 23
Rear panel
Table 1-3. Rear panel component descriptions
Number
Component
Description
1
Power connector
The library connects to a 110/220 volt ac power
supply.
2
Power switch
The library is powered ON when the power supply
switch on the rear panel is ON (|). The library has no
independent power switch on the front panel.
3
SAS host interface
connector
Serial-attached SCSI host interface cable connection.
The Ultrium 4, 5, and 6 SAS drives use the SFF-8088
connection at the drive end and SFF-8088 or SFF-8470
at the host adapter end.
4
Ethernet port
This port is used to connect the library to a network.
5
Accessor locking screw The accessor locking screw is used to lock the
accessor in place during transportation.
Important:
Remove the accessor locking screw before
the library is powered ON.
6
Air vent
These vents allow air to escape from the power
supply and tape drive sled.
4
5
1
2
6
3
a29z0003
Figure 1-5. Rear panel components
Chapter 1. Product description
1-5