Dell PowerVault TL1000 - Manual (Page 46)

Attaching the library to a server
The drive is attached to a server with the Serial Attached SCSI (SAS) interface. The
Web User Interface accesses the library with an ethernet interface.
Connecting the Host Interface cables
To connect the host interface cable to the library:
Note: It is recommended that you shut down and turn OFF the associated server
before you connect the SAS interface cable. Turn ON the associated server
after the SAS interface cable is connected to the library and server, the
library is powered ON, and the library completed the initialization.
1. Attach an ethernet cable to the ethernet port ( 1 in Figure 3-10)
Note: On rack mount installations, run the cable through the hook-and-loop
fastener strap on the right rear bracket.
a29z0102
1
Figure 3-9. accessor locking screw
a
29z0100
1 2 3
Figure 3-10. Interface cable connection
3-8 Dell PowerVault TL1000 Tape Autoloader User's Guide