Configuring trap notifications, Trap notifications – Dell PowerVault TL1000 User Manual
Page 59
Configuring trap notifications
Note:
This procedure is optional. SNMP notifications are not enabled unless there
is a check mark in the SNMP Enabled check box. To disable SNMP
notifications, clear the SNMP Enable check box and click Submit.
The traps that are supported by the TL1000 Tape Autoloader are listed in “Trap
definitions (types)” on page A-14.
To set up trap notifications for an SNMP server:
1.
Expand Configure Library, if necessary, and click Notifications in the left
navigation pane of the Web User Interface.
2.
Click the SNMP Settings tab.
3.
Click to place a check mark in the SNMP Enabled check box.
4.
Configure the SNMP server and header settings.
v
Community
- SNMP community name to which the library belongs.
v
Name
- Unique SNMP name for the system.
v
Location
- Physical location of the system.
v
Contact
- Contact person's name.
v
SNMPv3 engine ID
- A read-only attribute that identifies the SNMPv3
engine.
5.
Enter the trap IP addresses of the SNMP monitoring stations to be notified
when an event takes place and the security settings in the Trap List menu.
a29z0128
Figure 3-21. Trap notifications
Chapter 3. Installation and configuration
3-21
|