Dell PowerVault TL1000 - Manual (Page 55)

– Prefix length - Decimal value that indicates the number of contiguous,
high-order bits comprising the network portion of the address.
– Gateway - Allows access outside the local network.
v DNS setting - Select Use DNS to use a domain name server. The DNS
server, if entered, allows the encryption, date and time, and notifications IP
addresses to be specified with host names instead of numerical IP addresses.
– DNS IP address - Sets the IP address of the DNS server.
4. Click Submit to enable the settings.
Configuring date and time settings
Configure the date and time settings with one of three methods: automatically with
a remote NTP time server on the network, automatically with the clock on your
host computer, or manually.
Note: Selecting Refresh refreshes the date and time.
Note: If you choose to manually set your date and time, you must reset the date
and time after the library is power-cycled and after a library reset.
Note: When the library is power-cycled, wait 10 seconds after the power is OFF
before the library is powered ON again.
Once the network settings are entered on the Operator Panel, the current date and
time can be modified with the Web User Interface.
The TL1000 Tape Autoloader communicates with an NTP server with the following
conditions:
v Client/server basis operation
v UDP (User Datagram Protocol) to access the NTP server
v Does not use authentication keys
v Library polling is every 12 hours
To modify the date and time settings:
1.
Expand Configure Library, if necessary, and click Date and Time in the left
navigation pane of the Web User Interface.
2. Select the Date and Time settings.
v NTP Server - Enables time and date control with a time server on the
network.
a29z0170
Figure 3-17. Date and time settings
Chapter 3. Installation and configuration 3-17
|