Dell PowerVault TL1000 - Manual (Page 49)

Table 3-2. Default library configuration settings (continued)
Configuration Item Default Setting
Library mode Random
Loop Enabled
Auto Load Enabled
Active slots 9 + 0
ENCRYPTION
Encryption method None
DATE and TIME
NTP server Disabled
NTP server address 0.0.0.0
Time zone (GMT) +00:00
Date (MM/DD/YYYY) 01/08/2008
Auto adjustment by PC Every 1 minute
NOTIFICATIONS
SMTP (mail) settings
Mail server address 0.0.0.0
Mail event Error events enabled
SNMP (trap) settings
Community Public
Trap event Error events enabled
SNMPv3 engine ID (Set by library firmware)
Static library network settings must be entered with the Operator Panel before the
library can be accessed remotely with the Web User Interface. If your system is
serviced by a Dynamic Host Configuration Protocol (DHCP) server, the network
parameters are automatically set. Once remote access is established, you can
complete the configuration of your library remotely.
If you choose to use the Operator Panel to configure your library, go to
“Configuring your library with the Operator Panel” on page 3-24.
Configuring your library with the Web User Interface
If you choose to use the Web User Interface to configure your library, first enter
your library network settings with the Operator Panel (see “Configuring network
settings” on page 4-12).
To configure your library with the Web User Interface:
1. Install Java 1.5.0 or higher on your host computer. Download the latest
version of the Java Runtime Environment (JRE) for your platform from
http://www.java.com/.
2. “Logging in to the Web User Interface” on page 3-12
3. “Checking firmware level” on page 3-13
4. “Configuring library settings” on page 3-14
5. “Configuring network settings” on page 3-16
6. “Configuring date and time settings” on page 3-17
Chapter 3. Installation and configuration 3-11