Dell PowerVault TL1000 - Manual (Page 99)

Configuring SNMP trap notifications
Use Configure Library > Notifications > SNMP Settings to configure the trap
settings for sending event information whenever an event of a certain level occurs,
and to register users who can access the tape library with SNMP Version 3. The
traps that are supported by the TL1000 Tape Autoloader are listed in “Trap
definitions (types)” on page A-14.
Download the SNMP MIB file for this library from http://www.dell.com/support.
Install the MIB file on your SNMP server. Refer to your server application
documentation for instructions.
Configure SNMP trap notification with the following settings:
v SNMP Enabled - The SNMP Enabled check box must have a check mark to
enable SNMP notifications.
v Community - SNMP community name (for example, “public”)
v Name - Device name (for example, “TL1000 Tape Autoloader”)
v Location - Physical location of the tape library
v Contact - Contact individual's name
v SNMPv3 engine ID - A read-only attribute that identifies the SNMPv3 engine.
v Trap event - Event level notification threshold
– Error events
– Error and Warning events
– Error, Warning, and Information events
v Trap List - IP addresses of the SNMP monitoring stations to be notified when an
event takes place and the security settings.
– Validity - Enable/Disable setting.
– Trap version - v1, v2c, or v3. For v2c and v3, the Inform check box
determines whether an SNMP INFORM request is sent instead of a trap
event.
a29z0128
Figure 4-45. SNMP settings screen
Chapter 4. Operations 4-31
|
|