Dell DX6000 - Manual (Page 115)

Installing System Components 115
6 If not already done, route the interface and RAID battery cables in the
cable path inside the right interior wall of the chassis beneath the cable
retention bracket. See "Cable Routing" on page 118 and Figure 3-18.
7 Connect the SAS A cable to the SAS A connector on the backplane and,
if applicable, connect the SAS B cable to the SAS B connector on
the backplane.
8 Close the system. See "Closing the System" on page 83.
9 Reconnect your system and peripherals to their electrical outlets, and turn
on the system.
Figure 3-18. Storage Controller Card Cabling
1 RAID battery (PERC only) 2 SAS B connector on backplane
3 SAS A connector on backplane 4 cable retention bracket
5 integrated storage controller card 6 SAS_0 connector
7 SAS_1 connector 8 RAID battery connector (PERC only)
2 7 4 3 5 1 6 8