Dell DX6000 - Manual (Page 152)

152 Installing System Components
Figure 3-31. System Board Removal
Installing the System Board
CAUTION: Many repairs may only be done by a certified service technician.
You should only perform troubleshooting and simple repairs as authorized in
your product documentation, or as directed by the online or telephone service
and support team. Damage due to servicing that is not authorized by Dell is not
covered by your warranty. Read and follow the safety instructions that came
with the product.
1 Unpack the new system board and remove the label placard that is inserted
in the memory module socket.
2 Remove the labels from the placard and affix them to the information tag
on the front of the system. See Figure 1-1.
3 Transfer the processor and heat sink to the new system board. See
"Removing a Processor" on page 138.
4 Remove the memory modules and transfer them to the same locations on
the new board. See "Removing Memory Modules" on page 137 and
"Installing Memory Modules" on page 135.
1 system-board tray riser release pin 2 system board
2
1