Dell DX6000 - Manual (Page 118)

118 Installing System Components
Cable Routing
Cables that extend through the system front-to-back are routed along a cable
path within the interior right wall of the system chassis. The cables are
secured by a cable retention bracket that attaches to the inner wall.
Removing the Cable Retention Bracket
CAUTION: Many repairs may only be done by a certified service technician.
You should only perform troubleshooting and simple repairs as authorized in
your product documentation, or as directed by the online or telephone service
and support team. Damage due to servicing that is not authorized by Dell is not
covered by your warranty. Read and follow the safety instructions that came
with the product.
1 Remove the cooling shroud. See "Removing the Cooling Shroud" on
page 103.
2 Remove the cooling fan bracket. See "Removing the Fan Bracket" on
page 107.
3 Press outward on the blue release latch on the cable retention bracket and
slide the bracket back until the tabs at the bottom of the bracket clear the
chassis. See Figure 3-20.
4 Lift the cable retention bracket off the chassis wall.