Dell DX6000 - Manual (Page 153)

Installing System Components 153
5 Angle the system board as you lower it into the chassis and set the board
flat inside the chassis.
6 Maneuver the system board so that all of the retention hooks on the
chassis are inserted into the retention slots on the system board.
7 Push the system board toward the back of the chassis until the blue
retention pin locks into place.
8 If applicable, transfer the NIC hardware key.
9 Replace the riser boards. See "Replacing Expansion-Card Riser 1" on
page 125 and "Replacing Expansion-Card Riser 2" on page 127.
10 Reinstall the integrated storage controller card. See "Installing the
Integrated Storage Controller Card" on page 113.
11 If applicable, reconnect the RAID battery cable to the storage controller
card.
12 Reconnect all power and interface cables (see Figure 6-2 for the locations
of the connectors on the system board).
13 If removed, reinstall the SAS backplane and all hard drives. See "System
Board" on page 150.
14 Install all expansion cards. See "Installing an Expansion Card" on page 121.
15 If applicable, transfer the iDRAC6 Enterprise card to the new system
board. See "Installing an iDRAC6 Enterprise Card" on page 98.
16 Replace the fan bracket. See "Replacing the Fan Bracket" on page 108.
17 Replace the cooling shroud. See "Installing the Cooling Shroud" on
page 104.
18 Close the system. See "Closing the System" on page 83.
19 Reconnect the system to its electrical outlet and turn the system on,
including any attached peripherals.