AVer SA series - Manual (Page 173)

165
that has an alarm occurred will be displayed on TV.
 Camera #(1~32): select the camera channel video that wants to be displayed on TV
when an alarm is activated.
b. Retrieve time: set the waiting duration before system switching back to original display mode
on TV automatically. If the retrieve time is un-mark, the alarm video will keep displaying until
user switch back to normal display mode manually. The retrieve time range is 3~ 600
seconds.
- Enlarge Camera View
Switch to only display video in Preview mode from where the alarm is activated.
a. Select the camera from drop down list to specify which camera video to be enlarged on
screen when the alarm is triggered.

Alarm Camera: when a channel has an alarm occurred, and then, the channel video
that has an alarm occurred will be enlarged on screen.
 Camera # (1~32): the selected channel video that will be enlarged on screen when an
alarm is activated.
b. Retrieve time: set the waiting duration before system switching back to original Preview
mode. If the retrieve time is un-mark, the alarm video will keep enlarging until user switch
back to Preview mode manually. The retrieve time range is 3~ 600 seconds.
- Relay Output
Set to enable/disable the relay operation when the alarm is activated and to extend additional time
in second before it stops the relay operation (see also
Chapter 4.9.1 ).
- IP Camera Relay
To trigger on/off IP camera relay.