AVer SA series - Manual (Page 200)

192
- Voice Detecting Recording
DVR system will record the sound when the voice exceeds the intensity value in Voice Detection
setting.
- No Recording
The system won’t do any recording.
- KeyFrame Recording
Only record one frame per second.
(3) Motion Detection
Adjust the sensitivity of the motion detector. The higher the value, the finer the sensitivity is detected. When it
detects a motion, a green triangle mark would appear at the upper left corner of the screen.
(4) Voice Detection
Adjust the intensity of the audio detector. The system detects sound when it exceeds the intensity value.
(5) Quality
Adjust the video quality. The higher the value, the lower the compression level and uses more hard disk
space.
(6) Frame Rate
Set the maximum number of frames to be recorded during motion and motionless state. The frame rate
ranges from 1 to 30 for NTSC and 1 to 25 for PAL. The higher the frame rate, it uses more hard disk space.
(7) Video Size
User can activate the Enable Deinterlace to enhance the video quality. Set the Enable Deinterlace mode to
#1, if you are capturing motionless picture and #2, if it captures lots of movement.
(8) Compression Type
H264 is the latest and advanced video compression format that delivers better video quality and smaller file
size but this uses more CPU resource. Advanced MPEG4 provides a standard for color picture compression
rate.
Network Setting
In the Network Setting window, click Update to accept the new settings, click Exit to exit without saving, and
click Default to revert back to original factory settings. For the network service ports that use by DVR server,
please see
Appendix A .
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(9)
(10)
(1) Server Name
Assign a name for the DVR unit. Letters of the alphabet and numbers only.
(2) Transmitting Cameras
Select and click on the camera number in the Transmitting Camera section you want to make it accessible
via internet using WebCam, Remote Console, PDA Viewer and HandyViewer (still image). To select all the
cameras, enable the ALL check box.