AVer SA series - Manual (Page 179)

171
4.9.7 To Setup SMS/MMS Setting:
To use this feature, GSM/GPRS modem is required. Connect the GSM/GPRS modem to the serial COMM
port of PC. Beside the SMS/MMS check box, click Detail.
Select the port number in Com Port drop down list from where the GSM/GPRS modem is connected.
1. Click Modem Setup button to automatically detect the Modem Baud Rate.
2. In Local Phone Number text box, enter the GSM SIM card phone number.
3. In Phone Num text box, enter the contact number.
4. You may now set to send thru SMS &/or MMS. If you enable SMS setting, just enter the message in the
text box. If you enable MMS, enter the APN name, WAP IP, MMS address and the message. If you are
not sure, please contact your mobile service provider.
5. Attach image when sensor is triggered select the camera that the images will be capture and send
when the sensor is triggered.
6. Click OK to accept the new settings and Cancel to exit without saving.
i
Make sure your ISP provider and cell phone provider both support JPG file format transmitting.