Kontron TIGW1U Carrier Grade Server - Manual (Page 100)

TIGW1U server—Regulatory and Certification Information
Kontron Carrier Grade Server TIGW1U
Product Guide, rev. 1.3 December 2009
100
• FCC/ICES-003 Class A Verification Report (USA/Canada)
• VCCI Certification (Japan)
• C-Tick Declaration of Conformity (Australia)
• BSMI Certification (Taiwan)
• GOST R Certification/License (Russia)
• RRL Certification (Korea)
• CNCA Certification (China)
• Ecology Declaration (International)
Note: The TIGW1U server is not suitable for use with a visual display workplace device
according to the German Ordinance for Work with Visual Display Units because it has a
glossy front.
B.2 Electromagnetic Compatibility Notices
B.2.1 FCC (USA)
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
For questions related to the EMC performance of this product, contact your Kontron
sales representative.
This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment to an outlet on a circuit other than the one to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Any changes or modifications not expressly approved by the grantee of this device
could void the user's authority to operate the equipment. The customer is responsible
for ensuring compliance of the modified product.
Only peripherals (computer input/output devices, terminals, printers, etc.) that comply
with FCC Class A or B limits may be attached to this computer product. Operation with
noncompliant peripherals is likely to result in interference to radio and TV reception.
All cables used to connect to peripherals must be shielded and grounded. Operation
with cables connected to peripherals that are not shielded and grounded may result in
interference to radio and TV reception.