Kontron TIGW1U Carrier Grade Server - Manual (Page 43)

Kontron Carrier Grade Server TIGW1U
December 2009 Product Guide, rev. 1.3
43
Server Installations and Upgrades—TIGW1U server
3.4.5.2 Removing a PCI card from the Riser Card Assembly
Caution: When handling a PCI card, observe safety and ESD precautions. See Appendix A,
“Safety Information” for more information.
1. Turn the riser card assembly upside-down to remove the PCI card.
2. Remove the rear retention screw from the riser card. (“A” in
Figure 29 )
3. Detach the PCI card from the riser card connector. (“B”)
3.4.5.3 Installing a PCI Card in the Riser Card Assembly
Caution: When handling a PCI card, observe safety and ESD precautions. See Appendix A,
“Safety Information” for more information.
The following procedure uses a PCIe card as the example.
1. If the current riser card in the assembly is not correct for the PCI card you are
installing, i.e., in this example, the default PCI-X riser card instead of a PCIe riser
card, do the following:
Figure 28. Removing the Riser Card Assembly
TS000211
C
A
B
D
Figure 29. Removing a PCI-X Card from the Riser Card Assembly
TS000213
A
B