Kontron TIGW1U Carrier Grade Server - Manual (Page 41)

Kontron Carrier Grade Server TIGW1U
December 2009 Product Guide, rev. 1.3
41
Server Installations and Upgrades—TIGW1U server
5. Close the load plate. ( Figure 27 , “A”)
6. Close the socket lever and ensure that the load plate tab engages under the socket
lever when fully closed. (“B” and “C”)
3.4.4.4 Setting the Processor Select Jumper
The server ships pre-configured for the Dual-Core Intel ® Xeon ® processor 5100 series.
To use a Quad-Core Intel ® Xeon ® processor 5400 series, you must appropriately
configure the processor select jumper.
• For a Dual-Core Intel ® Xeon ® processor 5100 Series, make sure the jumper is
installed on pins 1-2 on the processor select jumper.
• For a Quad-Core Intel ® Xeon ® processor 5400 series, remove the jumper.
Caution: Never install the processor select jumper on pins 2-3. Your system will not boot if these
pins are jumpered.
This jumper is located at position J3E2 on the server board. See the following figure.
3.4.4.5 Installing the Heat Sink
1. If this is a new heat sink (not one you removed in Section 3.4.4.2 ), remove the
protective film from the Thermal Interface Material (TIM) located on the bottom of
the heat sink, if present.
Figure 27. Closing the Processor Load Plate and Socket Lever
A
C
B
AF000773
CPU CPU
J3E2
1 2 3
1 2 3
for Dual-Core Intel ®
Xeon ® Processor
5100 Series:
for Quad-Core Intel ®
Xeon ® Processor
5400 Series:
NO jumper
installed.
Install jumper
over pins 1-2.
CAUTION: Jumper J3E2 must be
configured to match your installed
processor or your system will not boot
properly.
Server
Board