Kontron TIGW1U Carrier Grade Server - Manual (Page 46)

TIGW1U server—Server Installations and Upgrades
Kontron Carrier Grade Server TIGW1U
Product Guide, rev. 1.3 December 2009
46
3.4.6 Installing a SMART Embedded USB Solid-State Drive
The SMART Embedded USB Solid-State Drive (eUSB SSD) is a removable media device
that provides local memory storage for options like system information, diagnostic
partitions, and configuration data. The solid-state drive is installed on top of the drive
bays in front of the SFP board. See Figure 9 for the cable connector location.
1. Plug one end of the cable labeled “SysCon” into the interposer board. (“A” in
Figure 32 )
Note: The connectors on both ends of this cable are identical.
2. Use the two screws to attach the interposer card to the standoffs on top of the
drive bay. (“B”)
3. Plug the other end of the SysCon cable into the connector on the SFP board. (“C”)
4. Attach the eUSB SSD to the interposer card. (“D”)
5. Insert and tighten the screw that will secure the eUSB SSD to the interposer card.
(“E”)
Figure 32. Installing the SMART Embedded USB Solid-State Drive
B
A
C
D
E
TS000291