Kontron TIGW1U Carrier Grade Server - Manual (Page 23)

Kontron Carrier Grade Server TIGW1U
December 2009 Product Guide, rev. 1.3
23
Server Installations and Upgrades—TIGW1U server
3 Server Installations and Upgrades
3.1 Before You Begin
Before working with your server product, pay close attention to the safety instructions
provided in this manual. See Appendix A, “Safety Information” .
Warning: Electrostatic discharge (ESD) and ESD protection: ESD can damage disk drives,
boards, and other parts. We recommend that you perform all procedures in this chapter
only at an ESD workstation. If an ESD workstation is not available, provide some ESD
protection by wearing an antistatic wrist strap attached to chassis ground (any
unpainted metal surface) on your server when handling parts.
3.1.1 Tools and Supplies Needed
• Phillips* (cross-point) screwdriver (#1 bit and #2 bit)
• Anti-static wrist strap and conductive foam pad
3.1.2 System References
All references to left, right, front, top, and bottom assume that you are facing the front
of the server, as it would be positioned for normal operation.
3.1.3 Cable Routing Reference
It is important for cables to be connected correctly. See Figure 9 . For more detailed
information about cable connectors, see the Kontron Carrier Grade Server TIGW1U
Technical Product Specification.