Kontron TIGW1U Carrier Grade Server - Manual (Page 29)

Kontron Carrier Grade Server TIGW1U
December 2009 Product Guide, rev. 1.3
29
Server Installations and Upgrades—TIGW1U server
2. Install the new drive in the drive tray and secure the drive with the four screws that
come with the drive tray. (“A” and “B” in Figure 15 )
3. With the drive tray locking lever fully open, push the hard drive tray into the drive
bay in the chassis until it stops. (“A”, “B” and “C” in Figure 16 )
4. Press the lever until it snaps shut to close the drive in the bay. (“D”)
5. Replace the front bezel.
3.3.2 Replacing a Power Supply Module
Caution: Your server does not have a redundant power supply unless you have purchased the
optional second power supply module. If there is no second supply, before replacing the
power supply you must first take the server out of service, turn off all peripheral
devices connected to the system, turn off the system by pressing the power button,
and unplug the power cord from the system or wall outlet.
Figure 15. Installing a Hard Drive
AF000810
A
B
Figure 16. Inserting a New Drive Assembly into the Chassis
AF000809
A
C
B
D