Kontron TIGW1U Carrier Grade Server - Manual (Page 50)

TIGW1U server—Server Installations and Upgrades
Kontron Carrier Grade Server TIGW1U
Product Guide, rev. 1.3 December 2009
50
3.4.7.2 Installing the RAID Activation Key and the ECC Mini-DIMM
The Intel ® RAID Activation Key connector and the mini-DIMM slot are located on the
SFP board.
1. Open both levers on the RAID mini-DIMM slot. (“A” in Figure 36 )
2. Note the location of the notch on the DIMM edge (“C”) and ensure that the DIMM
aligns correctly with the slot. (“B”)
3. Using both hands, press down firmly and evenly on the DIMM until it snaps into
place and the latches close. (“D”)
4. Insert the RAID activation key into the socket. (“E”)
Make sure that the metal clips on the socket snap over the top edge of the key.
3.5 Internal System Component Replacement Procedures
This section provides instructions for replacing internal system components that are not
hot-swappable when they fail.
Note: The procedures in this section assume that you have powered down the server and
removed the chassis cover as described in Section 3.2, “General Installation
Procedures” on page 24 .
3.5.1 Replacing an Optical Device
A DVD-ROM device comes pre-installed in the Carrier Grade Server TIGW1U. This
device is not hot-swappable. To replace the drive, you must first power down the
system and remove the chassis cover as described in Section 3.2, “General Installation
Procedures” on page 24 .
Figure 36. Installing the Intel ® RAID Activation Key and Mini-DIMM
E
D
A
B
C
TS000295