Kontron TIGW1U Carrier Grade Server - Manual (Page 62)

TIGW1U server—Server Installations and Upgrades
Kontron Carrier Grade Server TIGW1U
Product Guide, rev. 1.3 December 2009
62
Figure 51. Installing the PDB
3. Connect all power cables and the edge connector (“B”).
4. Install the PCI fan air duct and the chassis cover.
3.5.6 Replacing the Server Board
The Carrier Grade Server TIGW1U uses the Intel ® Server Board S5000PHB server
board. To replace the server board, the following components must be removed:
All components on the server board:
• Heat sink(s)
• Processor(s)
• All DIMMs
• PCI riser assembly
• Four-fan assembly
To replace the server board, use the following instructions.
Caution: Before replacing a board, you must first take the server out of service, turn off all
peripheral devices connected to the system, turn off the system by pressing the power
button, and unplug the power cord from the system or wall outlet.
When handling this board or any of the components on it, observe safety and ESD
precautions. See Appendix A, “Safety Information” for more information.
3.5.6.1 Removing the Server Board
1. Power down the server system and unplug all peripheral devices and the power
cable.
2. Remove the chassis cover and processor air duct.
3. Remove the PCI riser assembly. For instructions, see
Section 3.4.5.1, “Removing
the PCI Riser Card Assembly” on page 42 .
4. Remove all DIMMs. For instructions, see Section 3.4.3.2, “Removing DIMMs” on
page 37 .
TS000208
B
A
C