Kontron TIGW1U Carrier Grade Server - Manual (Page 28)

TIGW1U server—Server Installations and Upgrades
Kontron Carrier Grade Server TIGW1U
Product Guide, rev. 1.3 December 2009
28
3.3.1.1 Removing a Hard Drive Tray from the Chassis
1. Remove the front bezel. For instructions, see Section 3.2.3, “Removing the Front
Bezel” on page 25 .
2. Select the drive bay where you want to install the drive. Remove the drive tray by
pressing the green button to open the lever.
Note: If you will have fewer than three drives installed, drive bay 0 must be used first, then
drive bay 1.
3. Pull the drive tray assembly out of the chassis. (“A” in Figure 13 )
3.3.1.2 Attaching a Hard Drive to the Drive Tray
1. If a drive is already installed (that is, if you are replacing the drive), remove it by
unfastening the four screws that attach it to the drive tray. (“A” in Figure 14 )
Figure 13. Removing a Drive Tray from the Chassis
A
TS000218
Figure 14. Removing a Disk Drive from the Drive Tray
TS000219
A