CANOGA PERKINS 9145E NID Software Version 3.0 - Manual (Page 132)

9145E NID Software User’s Manual Service OAM
SOAM Configuration
118
Figure 11-6. SOAM Configuration
NOTE:You can perform system-level configuration before or after you con-
figure Maintenance Domains or other entities.
4. On the SOAM System Level Configuration screen (Figure 11-7), type 1 and press
<Enter>.
5. Toggle between Enabled and Disabled and press <Enter>. If Service OAM procedures
are disabled for the system, no Service OAM packets are captured and processed.
Instead, all Service OAM packets received by the 9145E NID are transparently for-
warded, using the same rules as for data plane traffic.
6. When you are prompted to change SOAM status, type Y and press <Enter> to save the
setting, or type N to return to the original setting.
7. To select a Chassis ID Format, type 2 and press <Enter>. Select one of the following set-
tings:
• MAC Address, and press <Enter>. The Chassis ID value is read only. You cannot
change the value on this screen.
• Network Address, and press <Enter>. The Network Address value is read only. You can-
not change the value on this screen.
• Locally Assigned, and press <Enter>. This selection allows you to enter a custom string.
Canoga Perkins Corp. Ethernet Network Interface Device 02-JAN-2009
Model 9145E-104-0-0 V3.00 F214 05:15:27
------------------------------SOAM CONFIGURATION-------------------------------
1) System level configuration
2) Maintenance Domains (MDs)
3) Maintenance Associations (MAs)
4) Maintenance Entity Groups (MEGs)
5) Maintenance End Points (MEPs)
6) Maintenance Intermediate Points (MIPs)
Select [1-6]:
------------------------------------Messages-----------------------------------