CANOGA PERKINS 9145E NID Software Version 3.0 - Manual (Page 25)

System Configuration 9145E NID Software User’s Manual
IP/SNMP Agent Configuration
11
Figure 3-3 Management IP configuration Menu
NOTE: The Test IP is used for PM and SAM testing. If PM and SAM are not licensed,
the Test IP address can not be entered.
5. Test IP Address - Used to set the IP Address for PM and SAM optional applications.
Test Subnet Mask - Used to set the Subnet Mask for PM and SAM optional applications.
6. Test Port - Used to select which port(s) allow access to the Test IP address. Parameters include:
Both User and Net Ports, Net Port Only, User Port Only, or No Ports Allowed.
7. Telnet Security - Used to enable or disable checking if the host initiating the Telnet session is
listed in the host table. If Telnet Security is enabled the host must be included as part of the host table.
Default is disabled, which allows access from all hosts.
8. Reply to Broadcast Ping - Use to enable or disable the 9145E to reply to ICMP packets with a
broadcast IP Host Address in the Manager IP subnet. Broadcast Ping replies are an ICMP packet and
are rate limited to 100pps. Default is disabled.
3.1.2 Auxiliary IP Configuration
The Auxiliary IP is an additional IP address that is provided for testing and connectivity only. It
allows the 9145E to be PINGed without allowing Telnet or Management access that could be
disruptive. The Auxiliary IP rate is limited to 500 pings per second. This allows connectivity and
rudimentary performance testing from subscriber/user VLANs without compromising network
security.
Configure the parameters by typing the corresponding number and pressing Enter. Enter data or
press the Space Bar to cycle through the configuration choices for the parameters described
below.
Canoga Perkins Corp. Ethernet Network Interface Device 29-JAN-2009
Model 9145E-101-3-0 V43.08 F211 11:43:26
-------------------------------MANAGEMENT IP CONFIGURATION---------------------
In-band Manager MAC Address 00 40 2A 02 2C D8
Manager MAC Address (In-band) 00 40 2A 02 2C D8
Manager Port Status UP
1) Manager IP Address 172.016.142.239
Subnet Mask 255.255.000.000
Default Gateway 172.016.001.001
2) Manager Port Both User and Net Ports
3) Manager VLAN Tagging Disabled
4) Manager VLAN ID 0
5) Test IP Address 000.000.000.000
Test Subnet Mask 255.255.255.000
6) Test Port Both User and Net Ports
7) Telnet Security Disabled
8) Reply to Broadcast Ping Disabled