CANOGA PERKINS 9145E NID Software Version 3.0 - Manual (Page 58)

9145E NID Software User’s Manual Diagnostics
VLAN Loopback
44
Figure 4-7 802.1ag Loopback Configuration
19. Administration State : To enable or disable the loopback responder, type 1 and press
Enter. Cycle between Enable and Disable. Press Enter to confirm the setting.
20. VLAN ID : This is the VLAN ID to match for responding to LBMs (Loopback Messages
initiated by another agent).
To enter a VLAN ID or a range, type 2 and press Enter. Use Backspace to remove the current setting,
then type in the VLAN ID or range. Press Enter to confirm the setting.
21. MD Level : This is the Maintenance Domain (MD) Level to match for responding to
LBMs.
To change the Maintenance Domain (MD) Level, type 3 and press Enter. Use Backspace to remove
the current setting, then type in the new setting. Press Enter to confirm the setting.
22. Ether Type : This is the ethertype to match for responding to LBMs. 0000 indicates any
ethertype except IP ethertype (0x800). The default is 8902.
To change the Ether Type, type 4 and press Enter. Use Backspace to remove the current setting, then
type in the new setting. Press Enter to confirm the setting. Press Esc to return to the VLAN Loopback
menu.
Canoga Perkins Corp. Ethernet Network Interface Device 29-JAN-2009
Model 9145E-101-3-0 V43.08 F211 11:20:59
-------------------------802.1AG LOOPBACK CONFIGURATION------------------------
1) Administration State Enabled
2) VLAN ID (1-4094) 1-4094
3) MD Level (0-7) 0-7
4) Ether Type (4 Hex Digits) 8902
Select[1-4]:
------------------------------------Messages-----------------------------------