CANOGA PERKINS 9145E NID Software Version 3.0 - Manual (Page 35)

System Configuration 9145E NID Software User’s Manual
Trap Configuration
21
The System Log contains the log of all enabled Trap events.
1. To configure Traps, select Trap Configuration (2) from the System Configuration menu.
The Trap Configuration menu (Figure 3-13) opens.
2. Select the number of the trap group to change and press Enter. Cycle through the Log
Only, Send Only, Both Log And Send, or Disabled parameters using the Space Bar.
The Master Trap Control setting will override all other trap settings. For example, if the Master
Trap Control is set to Log Only, rather than set to Both Log And Send (as shown), all the other
traps will only log alarm events, regardless of the individual trap settings. If the Master Trap
Control is set to Log And Send, the individual traps will perform according to their individual
settings. Setting the Master Trap Control setting to Disabled will disable all traps.
3. Press Enter to close the editing function and then press Esc to return to the System
Configuration menu.
NOTE: The setting of the Master Trap Control will override all other trap settings.
cpTemperatureOverHighThresholdAlarm cpStatus.my
cpTemperatureHighThresholdAlarmCleared cpStatus.my
cpTemperatureWarningApproachingHigh-
Threshold
cpStatus.my
cpTemperatureHighThresholdWarning-
Cleared
cpStatus.my
cpTemperatureAlarmUnderLowThreshold cpStatus.my
cpTemperatureLowThresholdAlarmCleared cpStatus.my
cpTemperatureWarningApproachin-
gLowThreshold
cpStatus.my
cpTemperatureLowThresholdWarning-
Cleared
cpStatus.my
SFP Traps cpSfpRemoved cpSfpStatus.my
cpSfpInsertedInvalid cpSfpStatus.my
cpSfpInsertedValid cpSfpStatus.my
cpSfpTxOk cpSfpStatus.my
cpSfpTxWarning cpSfpStatus.my
cpSfpTxFailure cpSfpStatus.my
Trap Config Item Traps Affected MIB Location