CANOGA PERKINS 9145E NID Software Version 3.0 - Manual (Page 156)

9145E NID Software User’s Manual Service OAM
Maintenance End Points
142
Figure 11-26. SOAM Linktrace Report screen
11.6.7 Loopback Procedures
A loopback request is initiated by a MEP to verify the connectivity to a specified target MEP or
MIP in the network.
NOTE: Only one Loopback session can be active at a time for the entire
system.
11.6.7.1 Initiating a Loopback Request
1. On the Maintenance End Point Attributes screen (Figure 11-21 for 802.1ag or Figure 11-
22 for Y.1731), type L and press <Enter>.
• If a Loopback request was already initiated from the MEP, a Loopback Monitoring
screen (Figure 11-28 for unicast, Figure 11-29 for sweep, or Figure 11-30 for mul-
ticast) opens.
• Otherwise, the Loopback Request screen (Figure 11-31) opens.
Canoga Perkins Corp. Ethernet Network Interface Device 02-JAN-2009
Model 9145E-104-0-0 V3.00 F214 05:15:27
------------------------------SOAM LINKTRACE REPORT ----------------------------
Source MEP ID: 1
Destination: Mep ID: 2
MAC: 00:40:2A:01:ED:E3
Destination reached: Yes
Number of hops to destination: 1
Number of replies: 1
Reply number: 1
TTL: 62
Responder MAC address: 00:40:2A:01:ED:E3
LTM was forwarded: No
Terminal MEP was reached: Undefined
Relay action: Undefined
Egress action: Ok
Egress address: 00:40:2A:01:ED:E3
Select [(F)irst, (P)rev, (N)ext, (L)ast] to change pages,
R)efresh, ESC to return:
------------------------------------Messages-----------------------------------