Panasonic CQ VAD9300U - Manual (Page 21)

Cautions:
• For smooth adjustment, make sure to first return the lateral angle to the neutral position and then adjust the tilt angle.
• Avoid physical shock on the monitor.
[TILT]
(Adjust)
[A] [VI
[<][>]
(Adjust)
Tilt Angle/Front-Rear Position
Press and hold [TILT] on the display unit for more than 1 second.
Press [Al. [V]. [<] or [>] to adjust.
The setup is the same way as the one from MENU. Refer to
“SET-UP: User Settings” for details. page 40)
Notes:
• Vertical angle (TILT) and front-rear position data are saved in the memory, so
when the display unit is drawn out next, it is automaticaily set at the angle and
in the position adjusted before.
• After adjusting its angle, also adjust the brightness to make it easy for you to
watch. (=^ page 46)
• The car model and installation condition may impose some restrictions on the
adjustment of the monitor's angle and position.
Caution: Do not interfere with the movement of the monitor. Do not change
the position of the unit forcibly.
Display Unit Lateral Angle Adjustment
Hold the display unit by the non-slip part in the upper half of it, and adjust its
lateral angle.
View from above
Caution: There is the danger of your fingers being pinched if you hold the
unit by the lower part. Hold the unit by the upper half, and move it carefully
without applying undue force.
Folding Down the Display Temporarily
Fold Down; press [TILT] on the display unit.
Raise; press [TILT] again on the display unit.
Note: Even when the unit is power off, you can fold down the display temporarily.
Caution: Do not place any object on the display unit, or subject it to undue
force.
CQ-VAD9300U
21