Panasonic CQ VAD9300U - Manual (Page 75)

□ Installation Hardware (For Wiring)
No. Item Diagram Qty
@
Power Connector
(for display unit)
1
Reverse Extension Cord
(for rear view camera)
1
@) Clip Connector 1
Display Unit/Hide-away Unit
Connecting Cord %
1
Optical Fiber Cable
•o
1
Power Connector
(for hide-away unit)
1
Ground Lead 1
Radio Antenna Extension
Cord ■r"
1
@) Center Speaker Lead 1
Center Speaker Extension
Lead
1
Before you begin installation, iook for the following items
which are packed with your unit.
• Warranty Card....... Fill this out promptly.
• Panasonic Servicenter for Service Directory...............
Keep for future reference in case the product needs
servicing.
• Installation Hardware........Needed for Installation.
□ Before Installation
Warning
• Do not install the monitor in a location which
obstructs driving, visibility or which is prohibited by
applicable laws and regulations. If the monitor is
installed in a location which obstructs forward visibility
or operation of the air bag or other safety equipment or
which interferes with operation of the car, it may cause
an accident.
• Never use bolts or nuts from the car's safety devices for
installation. If bolts or nuts from the steering wheel,
brakes or other safety devices are used for installation
of the monitor, it may cause an accident.
•
• Attach the wires correctly. If the wiring is not correctly
performed, it may cause a fire or an accident. In particu­
lar, be sure to run and secure the lead wire so that it
does not get tangled with a screw or the moving portion
of a seat rail.
• Use with 12 volt DC negative ground car. This unit is
only for use with a 12 volt DC negative ground car. It
cannot be used in large trucks or diesel cars which are
24 volt DC cars. If it is used in the wrong type of car, it
may cause a fire or an accident.
Cautions:
• Use the specified fuse. Be sure to always use the
specified fuse. If a fuse other than the specified fuse
is used, it may cause a fire or an accident.
• Do not damage the cord by pinching or pulling it. Do
not pull or damage the cord. If the cord is not treated
properly, it will short out or be severed and may
cause a fire or an accident.
□ Required Tools
You’ll need a screwdriver and the following;
12 V DC
Test Bulb
Electrical
Tape
Side-Cut
Pliers
□ Dashboard Specifications
THICKNESS
MIN. 3/16” (4.75 mm)
II-— MAX. 7/32” (5.56 mm)
2-3/32” (53 mm)
7-5/32” (182 mm)
□ Identify All Leads
The first step in instailation is to identify all the car wires
you’ll use when hooking up your LCD monitor.
As you identify each wire, we suggest that you label it
using masking tape and a permanent marker. This will
help avoid confusion when making connections later.
Note: Do not connect the power connector to the display
unit until you have made all connections. If there are no
plastic caps on the hooking wires, insulate all exposed
leads with electrical tape until you are ready to use them.
Identify the leads in the following order.
CQ-VAD9300U
75