Panasonic CQ VAD9300U - Manual (Page 71)

Aspect Ratio
Default: NORMAL
Mode: 4 types Press [ASP] (ASPECT) on the display unit or press [A] (ASPECT) on the
remote control to change the aspect ratio as follows.
[ASP] (ASPECT)
[A] (ASPECT)
NORMAL
• The conventional display image has a 4
to 3 ratio of horizontal to vertical.
• In this case, a blank area remains on the
right and left sides of the display.
FULL
• The screen is extended horizontally as a
whole to the aspect ratio of 16 to 9.
• The extension ratio is the same at any
point of the screen.
ZOOM
• The screen is fully extended at the normal
aspect ratio of 4 to 3.
• The top and bottom of the screen are
slightly cut.
JUST
• The screen is extended horizontally to the
aspect ratio of 16 to 9.
• The extension ratio increases toward the
right and left ends of the screen.
Notes:
• This adjustment is common to TV, VTR1, VTR2, DVD and video CD mode.
• You cannot change the aspect in the menu screen and a screen in the CD, MP3, radio, CD changer and Sirius
mode. These are fixed to “FULL” as well as a Navigation Image.
• When the rear view camera is in operation with the transmission gear shift in the reverse position, the image is
shown on the “FULL” screen only.
• In some cases, the picture looks different from the original one due to your selection of aspect.
Cautions:
• This is to remind you that compression or extension of the screen using the aspect ratio [screen mode)
changing function of this product for commercial purpose of profit making or viewing/listening by the public
could infringe on the rights of the author protected by the copyright law.
• If you expand normal picture {4 to 3) by using “JUST”, “ZOOM” or “FULL” aspect to the full of the screen, you
might not see the periphery of the picture, or you might see a distorted picture. Therefore, use the “NOR­
MAL” mode to see the original picture as the author intended it.
CQ-VAD9300U
71