Panasonic CQ VAD9300U - Manual (Page 43)

[MODE]
(End)
[MENU]
[0]t0 [9]
[A] [V]
[<] [>]
(Select/adjust)
[ENTER]
Notes:
• Press [MODE] to return to the regular mode.
• The display returns to the previous one if there is no
operation for more than 60 seconds after changing to
the setting menu.
Setting
CAMERA SETUP
CAMERA INPUT Rearview camera input
OFF
VTR1
VTR2
: unconnected
: connected to the VTR1-1
; connected to the VTR2-I
® Press
[A]
or
[VI
to select
an item.
(D
Press [ > ] , [ < ] ,
[A]
or
[V]
to select or adjust the
setting.
d) Press [ENTER] to set.
Note: Make sure to select “OFF” when no rear view camera is connected.
Rear view camera scale display SCALE
OFF
ON
; scale display off
: scale display on
SCALE ADJUST Scale adjustment
Press [>] or [<] to adjust the width.
Press
[A]
or
[VI
fo adjust the angle.
Press [0] to [9] on the remote
control to input the ID code.
Caution: Record your regis­
tered ID code and keep it in a
secure location. If you forget it,
you will be unable to use the
unit. In case you forget the ID
code, please consult your near­
est Panasonic Servicenter.
Mow to set your ID code (for the first time)
® Enter an 4 digit ID code.
(D
Enter the same 4 digit ID code again.
How to change your ID code
CD Enter the preset (old) 4 digit ID code. If the wrong ID code is entered, a
new ID code cannot be registered.
(D Enter a new 4 digit ID code.
CD Enter the new 4 digit ID code again.
How to cancel the known ID code
Note: Should your unit ever require service, cancel your ID code before send­
ing for repair,
(D Enter the preset (old) 4 digit ID code. If the wrong ID code is entered, it is
not possible to cancel the ID code function.
© Press and hold [ENTER] until “Complete!” is displayed. The ID code can­
celling procedure is completed. The unit now works without an ID code.
Note: Refer to ID Code Input regarding how to enter the ID code. (=>■ page 11)
CQ-VAD9300U
43